south coast.... of Australia
It's been a sloooow start but im getting momentum.:o
the beast will be 2750mm x 1850mm with aproxamatly 250mm z but i need repeatable accuracy of 0.01mm :eek: need some advice on this issue, looking for resolution of at least 0.005mm to ensure acuracy. mostly aluminium part manufacture and mdf pattern making for casting, one is tolerance specific :( the other is a rough it out job;) any help? Regards, Andrew |
Andrew,
Did you read the other post's regarding your resolution request. Mr. Richards has put together a very good explaination of the expectations of the MM for your review. http://www.mechmate.com/forums/showt...&postcount=218 |
hi sean,
Oh no i looked it was not there, so i decided to introduce myself again after several years dosen't look good though:( cheers andrew |
All times are GMT -6. The time now is 02:02. |
Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.