how to slave x motors
I have a shobot prt 96.
when i tried to run this morning it jump the rail found out x motors moving in the same direction. need advise in resetting the slave . is there a step by step instructions anywhere ? If anyone can help thanks paul |
I believe Shopbot use their own software. Mechhmates typically use LinuxCNC or Mach.
I'm sure the guys over at http://www.talkshopbot.com/forum/forum.php will be able to help you. |
All times are GMT -6. The time now is 10:12. |
Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.