Newbie MM 101
I've been wanting to build my own CNC for quite sometime now and I found this site while looking for plans. Since MM is offering the plans for free...are there vendors for the parts, etc? I am not a welder so fabricating the table parts is out of my area of expertise. Any suggestions on where to start?
|
Welcome, Jake!
Keep reading these forums, and I think you'll discover quite a few non welders that have been successful. Speaking personally, the MM drove me to buy a welder (actually two, a classic Lincoln AC 225 stick welder on craigslist for $100, and then a knockoff mini-"MIG") and relearn to use them. I think that the design is straightforward for a novice metal worker; just take your time, and ask for help if you need it. And again, welcome! -Brad (#10) |
All times are GMT -6. The time now is 13:56. |
Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.