UIM 240xx step driver help.
Hi;
I'm sorry if I wrote the wrong topic section. problem with a link, http://www.mechmate.com/forums/showthread.php?t=2687 pdf files UIM240 model, the driver, I can not run with Mach3. I connected the LED pins on the XYZ axes running. Step pin: yes, okay - dir pin: yes, okay How where you need to connect the Vcc pin.? please help me. |
What type of BOB are you using ?
|
1 Attachment(s)
|
2 Attachment(s)
Quote:
Thanks for the help. I also looked at the photo (UIM240-pdf). you say your shape exactly. I asked, but, whichever LPT pin. or together to make another circuit. |
1 Attachment(s)
The pin from parallel port depends on your TYPE of BOB and where you pick up the connection
|
1 Attachment(s)
(The pin from parallel port depends on your TYPE of BOB and where you pick up the connection)
I'm sorry could not make gogle translation. I could not understand. My connection is like that. |
BOB = Break out board.
|
1 Attachment(s)
|
You still need to tell us which 'Break-out Board (BOB)' you are using WITH your stepper drivers (UIM240). You need a BOB to send the signals to the drives (UIM240).
|
window_s,
Break-out Board = 25 pin Interface board. What type of board did you use? |
This will be a difficult one :o
|
Actually, IMHO, any 25pin parallel port BOB will do... You can even run without one...
I recon Window_s has a language problem more then anything else. Give him/her some time... |
1 Attachment(s)
Would like to thank all the friends who helped me. No problem now. I find the cure. Solution of the problem is in the picture. |
to be very easy. :D
ULN2003 great device:D |
All times are GMT -6. The time now is 07:21. |
Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.