Router / Spindle cable management
For those of you with working Mechmates, how are you handling the wiring management of the z-slide? I think this would include cabling for the router/spindle power, ground wire, and in some cases the prox switch.:confused:
|
Greg,
I have a very stiff 3 core 12GA wiring for the router which I loop up and over the slide and zip tie to a nice hole I drilled in the slide plate. I will be adding cable chain to the slide in the very near future to make it all look sexy. JR, I think has one of the cleanest arrangements I have seen so far. Sean |
All times are GMT -6. The time now is 20:46. |
Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.