raw Particle board cutting
I need to cut a lot of 19mm Particle board, its raw, without melamine top.
Really its just packaging grade of board. Order is to cut about 20-30 sheets/month. There is around 35 pieces on one board so its a lot of cut path. Anyone has in mind some router bit to use? Edge quality is of no concern as it will be covered with fabric later. I need something rough that will just rip it apart :) had this in mind: http://www.cmtutensili.com/show_items.asp?pars=RC~196~2 around 35eur for 8mm , think that it will be strong enough to cut it in one pass. |
You may try with compression bit. :D
|
Compression bits are working for me when I have to cut sheet material.
|
digger:
samo ti zezaj I said its a low grade particle board with lot of impurities, and edge does not have to be perfect or good. So that is why I have not considered compression bit (price difference). |
All times are GMT -6. The time now is 16:18. |
Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.