MechMate CNC Router Forum - A nice idea for a jig clamp

MechMate CNC Router Forum (http://www.mechmate.com/forums/index.php)

- General - MM Operating (http://www.mechmate.com/forums/forumdisplay.php?f=85)

- - A nice idea for a jig clamp (http://www.mechmate.com/forums/showthread.php?t=3951)

silverdog

Sun 02 December 2012 05:25

A nice idea for a jig clamp

Ciao,
I found this video while surfing youtube
I think it's a nice idea/point to start for a an holdig clamp

http://www.youtube.com/watch?v=WmCzW...eature=channel

jessyjames

Sun 02 December 2012 21:23

Ya that video was made by my good friend Peter from down under. A swell chap for sure. His machine is a Joes cnc Hybrid

All times are GMT -6. The time now is 14:51.