Gcode for surfacing table
Gerald I do not know if this is right thread for this? As far as I remember JR also had similar question.
Is there any particular sequence in gcode while surfacing table or should I put simple gcode for doing so? |
DMS,
If you're using Mach, there is a surfacing wizard. Find it on the top toolbar. Chuck |
Thanks Chuck, I was not aware of that. I used JR's file for my setup.
|
All times are GMT -6. The time now is 00:40. |
Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.