MechMate CNC Router Forum

MechMate CNC Router Forum (http://www.mechmate.com/forums/index.php)
-   20. Gantry (http://www.mechmate.com/forums/forumdisplay.php?f=23)
-   -   Pictures of endstops (http://www.mechmate.com/forums/showthread.php?t=5731)

baseball43v3r Wed 25 September 2019 23:54

Pictures of endstops
 
Hey all,

I'm adding endstops to my machine (I know, I know, I should have done this a long time ago) but I can't figure out where the gantry and car hit the rails. I can see the end blocks on the plan, but I don't know what runs into it. Can someone post a couple of pictures of their endstops and where they make contact? thanks.

Gerald D Fri 27 September 2019 13:14

See this post for a pic of the "stop blocks" which are screwed to the carriages, and they hit the end-stops at the end of the rails

xraydude Sun 29 September 2019 15:46

2 Attachment(s)
Here's a pic of one of my X-rail stop blocks and a pic of my Y-rail stop block. I made these up myself per the plans. If you bought a laser cut kit, it probably has some bent/cut blocks in the kit.

Ted


All times are GMT -6. The time now is 07:05.

Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.