mark.haydock
Mon 08 September 2008, 22:49
I know it’s probably a legal issue or something but I would like to change the sizes of the table and do some 3D assembly construction in Solid Edge V20. For me being a engineer it makes things easier if I assemble them and test them in 3D cyberspace. I also work in inches which I can transfer back to the plans etc, and print out my custom sizes instead of white out and scribble marks.
Any way it’s just a question it beats pulling them off the pdf and converting them (not as accurate as the original dwg files) is there a full set of the MechMate available?
Regards,
Mark in Michigan
Any way it’s just a question it beats pulling them off the pdf and converting them (not as accurate as the original dwg files) is there a full set of the MechMate available?
Regards,
Mark in Michigan