Panovak
Sun 05 January 2020, 09:37
Hi guys,
I have an opportunity to buy used square linear rails. They are about 30mm. Two are 8'3" and two are 6'. These are very beefy rails.
These are used and I was told they were worn about 0.01". I'm not sure in what direction or how much of the rails is this worn.
My question is: how bad is 0.01"? Is the effect more profound than just throwing off accuracy 0.01"?
My other concern is I want to build a 4x8 machine. So I would have to cut and butt these linear rails. Is this going to be a big challenge?
He is asking very little for these.
Thanks for you help
I have an opportunity to buy used square linear rails. They are about 30mm. Two are 8'3" and two are 6'. These are very beefy rails.
These are used and I was told they were worn about 0.01". I'm not sure in what direction or how much of the rails is this worn.
My question is: how bad is 0.01"? Is the effect more profound than just throwing off accuracy 0.01"?
My other concern is I want to build a 4x8 machine. So I would have to cut and butt these linear rails. Is this going to be a big challenge?
He is asking very little for these.
Thanks for you help