GregA
Fri 11 January 2008, 07:00
I am looking for a a way to finish the wiring for the motors. The best idea I have had so far is molex plugs, then shrink tube up to the motor housing. I am concerned that it may still look a little... janky. As well as loose a little bit of flexibility in the wiring of the motors.
Any thoughts?
On Edit: Should I even consider disassembling the housing of the motor to bring the nice shielded wire right up to/inside the motor?
Any thoughts?
On Edit: Should I even consider disassembling the housing of the motor to bring the nice shielded wire right up to/inside the motor?