javeria
Sun 20 November 2016, 07:41
Hi Folks,
Its been a long time since I have posted anything on this forum, but wanted to share something, Have been using Eding CNC 's ethernet based controller for some time - seen that it works so very well - especially speeds have increased by 30% on relief machining.
I am no way related to Eding CNC except that I am a satisfied customer - I use this particular board
http://www.edingcnc.com/products.php?productid=55
Regards
Irfanulla
Its been a long time since I have posted anything on this forum, but wanted to share something, Have been using Eding CNC 's ethernet based controller for some time - seen that it works so very well - especially speeds have increased by 30% on relief machining.
I am no way related to Eding CNC except that I am a satisfied customer - I use this particular board
http://www.edingcnc.com/products.php?productid=55
Regards
Irfanulla