akelemen
Wed 08 July 2015, 11:39
Thanks to this great forum we successfully completed our MechMate and were able to make a first test cut yesterday:
https://www.youtube.com/watch?v=SX-hlOW8ZCc
Some details to the design which is pretty much standard except maybe the relatively large cutting area and the bolted design as a consequence, because we wanted to make it transportable in case we need to change location.
Here are some of the main parameters:
Cutting area: 3100x2070x30 mm
Stepper motors: Oriental motor PK296AE-SG7.2
Breakout board: PMDX-126 Rev. C
Motherboard for Gecko drive: PMDX-134
Stepper drive: G203V Digital Step Drive
Isolated Speed Control: PMDX-107 P
Spindle: 2.2kW 220V air cooled Chinese spindle with VFD
https://www.youtube.com/watch?v=SX-hlOW8ZCc
Some details to the design which is pretty much standard except maybe the relatively large cutting area and the bolted design as a consequence, because we wanted to make it transportable in case we need to change location.
Here are some of the main parameters:
Cutting area: 3100x2070x30 mm
Stepper motors: Oriental motor PK296AE-SG7.2
Breakout board: PMDX-126 Rev. C
Motherboard for Gecko drive: PMDX-134
Stepper drive: G203V Digital Step Drive
Isolated Speed Control: PMDX-107 P
Spindle: 2.2kW 220V air cooled Chinese spindle with VFD