st_indigo
Tue 10 February 2015, 20:56
Parts for five chairs from one sheet of 48x96x3/4 inch hardwood plywood with a 1/4 inch end mill.
Pockets on the four side parts should be milled 3/8" deep.
All edges on milled parts must be manually rounded on the router table with a 1/4" roundover bit before assembly, so there will be no need to use "dogbones" on the pockets.
You can, of course, modify these directions to suit your own assembly preferences.
Enjoy!
Philip
https://farm8.staticflickr.com/7411/16310400980_ebea727c02_o.jpg
Pockets on the four side parts should be milled 3/8" deep.
All edges on milled parts must be manually rounded on the router table with a 1/4" roundover bit before assembly, so there will be no need to use "dogbones" on the pockets.
You can, of course, modify these directions to suit your own assembly preferences.
Enjoy!
Philip
https://farm8.staticflickr.com/7411/16310400980_ebea727c02_o.jpg