Duds
Mon 20 October 2014, 15:36
Hi folks, I have a cheap air cooled spindle. The motor just has has a massive aluminium extrusion that it is pressed into. It has a matrix of tapped mount holes but I'm tempted to just drill the two holes for the dowel pins and fit a stud for the through hole mount on the z slide.
Or, should I create an adaptor plate with matrix of screws to hold the spindle and dowels and stud for the z slide.
Or, should I create an adaptor plate with matrix of screws to hold the spindle and dowels and stud for the z slide.