The Youngin
Wed 03 April 2013, 23:09
Ok,
So my mech mate is running very well. The only issue so far is that the cut is short ever so slightly. Tops 1/16 over 48 in (calipers show near perfection)
I've ran the steps per calculation, Still off ever so slightly....
The bit also does not end smooth every time (primarily on rectangles)
It produces a small lump at the start point. Way worse if I run lead ins.
I'm extremely frustrated,
And ideas would help,
Jason
So my mech mate is running very well. The only issue so far is that the cut is short ever so slightly. Tops 1/16 over 48 in (calipers show near perfection)
I've ran the steps per calculation, Still off ever so slightly....
The bit also does not end smooth every time (primarily on rectangles)
It produces a small lump at the start point. Way worse if I run lead ins.
I'm extremely frustrated,
And ideas would help,
Jason