sierra347
Fri 15 March 2013, 22:57
Hello everyone,
I decided to go with the Hitachi X200 3hp and the 1.5kw Chinese spindle but have been pulling my hair trying to get it to work right.
I can get it to run ok my problem is it keeps throwing a E07 code overvoltage due to regeneration energy from the spindle as it decelerates.
I've increased the deceleration time as high as 150 seconds but it still faults. I reset it to default settings and have the following basic settings.
A001-00
A002-02
A003-400
A004-400
A082-220
B012-10
H003-1.5kw
H004-2
I know a few members have this vfd, any help, suggestions or guidance would be greatly appreciated.
Thanks
I decided to go with the Hitachi X200 3hp and the 1.5kw Chinese spindle but have been pulling my hair trying to get it to work right.
I can get it to run ok my problem is it keeps throwing a E07 code overvoltage due to regeneration energy from the spindle as it decelerates.
I've increased the deceleration time as high as 150 seconds but it still faults. I reset it to default settings and have the following basic settings.
A001-00
A002-02
A003-400
A004-400
A082-220
B012-10
H003-1.5kw
H004-2
I know a few members have this vfd, any help, suggestions or guidance would be greatly appreciated.
Thanks