View Full Version : Bit Supplier
tangocharlie123
Sat 22 September 2012, 05:18
Hi Everyone
Doe's anybody have a good supplier that is current for Compression bits also specialty bits preferably on the cheaper side.
anywhere in the world but doesn't charge the earth for postage.
I am using carbidechui for end and ball nose mills.
Pete
MK_CATANZARO
Wed 26 September 2012, 08:24
I just found this place. The prices seem pretty fair all around. I've heard good things about southeast tool bits. I just placed my first order with them, set to arrive today.
http://www.carbideprocessors.com/
Quadro
Wed 26 September 2012, 15:51
Pete,
I'm also looking for some compession bits, I was after 1/4" or 6mm.
Have you had any luck?
Anthony
sailfl
Wed 26 September 2012, 16:57
I have been using bits from Centurion Tools
http://centuriontools.com
1/4" Mortise Compression 1" Cut Length
SKU: 14CR21.02.5FEM200
$27.80
I cut a lot of cheap China 3/4" ply and even after lots of sheet, they still give a good edge.
If they do not ship out of the country, I would consider an order to one location if you are interested.
tangocharlie123
Mon 10 December 2012, 18:51
Hi
Sorry for the delay
I found Multi Cam here in Brisbane thier prices are reasonable, postage is overnight freight.
I found on another site that due to the fact that I was after 1.5mmCED you could not get them so the suggestion was run a 1.5 down cut spiral then an upcut through over two passes this has given great results.
Cheers
Pete
vBulletin® v3.8.3, Copyright ©2000-2024, Jelsoft Enterprises Ltd.