thunderdork
Fri 07 September 2012, 20:00
Hi all,
I am not building a MechMate specifically but I am inspired by it and I've been documenting my build so far.
I reached my first miles stone with electronics. I built a control box with a CNC4PC C11 breakout board, a Keling KL-7220 power supply and I'm using Gecko g320x servo drivers. If its alright I'd like to post some of my current vids and future progress. Here is what I have so far for the control box:
My video walk through of my box:
http://thunderdork.com/diy-cnc-router-its-alive-control-box-and-servos-up-and-running/
My animation of wiring up my breakout board:
http://thunderdork.com/diy-cnc-router-cnc4pc-com-c11-wiring/
Hopefully this helps other people out. Feel free to follow me at thunderdork.com (http://www.thunderdork.com)
I am not building a MechMate specifically but I am inspired by it and I've been documenting my build so far.
I reached my first miles stone with electronics. I built a control box with a CNC4PC C11 breakout board, a Keling KL-7220 power supply and I'm using Gecko g320x servo drivers. If its alright I'd like to post some of my current vids and future progress. Here is what I have so far for the control box:
My video walk through of my box:
http://thunderdork.com/diy-cnc-router-its-alive-control-box-and-servos-up-and-running/
My animation of wiring up my breakout board:
http://thunderdork.com/diy-cnc-router-cnc4pc-com-c11-wiring/
Hopefully this helps other people out. Feel free to follow me at thunderdork.com (http://www.thunderdork.com)