Starting to make progress

[peter__jackson]

Well started today ,I have decieded to use servo moters with right angle gear boxes. and to include a 4 th axis from the start. I think this is going to be fun.

[MetalHead]

Welcome to the group!!!

[hennie]

Welcome Peter

[KenC]

Welcome! Servo motors, this would be another 1st.

[Anton20]

hi welcome to the forum.

[peter__jackson]

After a lot of set backs and having to build a workshop,finaly started to make progress , bought the cable today. finished interfaceing Mach3 with the servo packs.:)

[KenC]

That was fast! I meant building a workshop ...

[peter__jackson]

thanks ,lucky the machine is designed to bolt together so moving it was not a problem. But finding time to work on the machine is hard.but am nearly finished the z Axis, have to charge the gas lift for the correct counter balance then i can assemble