riesvantwisk
Tue 20 July 2010, 13:40
Somebody is geving a free webinar:
http://tinyurl.com/2abvkua
He will be using Rhino, RhinoCam and T-splines to make a part. With videos to show the machining. So if you are not familiar with Rhino/Rhinocam and or T-Splines then this is a quick intro.
He will promise that it will be paced well. Better than a family slide show 8)))
I am not associated with him, just wanted to pass on the message.
http://tinyurl.com/2abvkua
He will be using Rhino, RhinoCam and T-splines to make a part. With videos to show the machining. So if you are not familiar with Rhino/Rhinocam and or T-Splines then this is a quick intro.
He will promise that it will be paced well. Better than a family slide show 8)))
I am not associated with him, just wanted to pass on the message.