south coast.... of Australia

[southernduckie]

It's been a sloooow start but im getting momentum.:o
the beast will be 2750mm x 1850mm with aproxamatly 250mm z
but i need repeatable accuracy of 0.01mm :eek: need some advice on this issue, looking for resolution of at least 0.005mm to ensure acuracy.

mostly aluminium part manufacture and mdf pattern making for casting, one is tolerance specific :( the other is a rough it out job;)

any help?

Regards, Andrew

[smreish]

Andrew,
Did you read the other post's regarding your resolution request. Mr. Richards has put together a very good explaination of the expectations of the MM for your review.

http://www.mechmate.com/forums/showthread.php?p=42708&postcount=218

[southernduckie]

hi sean,

Oh no i looked it was not there, so i decided to introduce myself again after several years dosen't look good though:(

cheers andrew