Rich8449
Mon 28 December 2009, 18:21
Hi Everyone,
I've been wanting a CNC Router for a very long time. Only recently have I considered doing a build. In the past few weeks I have been spending a lot of time lurking around on the CNCZone DIY forum. A few days ago I was reading a comment from a veteran DIY'er who stated that his next build was going to be a MechMate. That was the first time I'd seen a reference to MechMate so naturally I came over here to check it out for myself. I'm quite impressed! I am still in the learning / planning stage but I've already downloaded the drawings and I have to say that of course Gerald has done an amazing job with the engineering side of things... He's also done an outstanding job maintaining the site and moderating the forum. I'm really looking forward to getting started and being an active member of the MechMate community!
I tend to do a lot of research so I probably won't start a build thread for awhile. I've been reading this forum non-stop but I still have a lot of reading to do. Just thought I'd start out by thanking everyone for their contributions. You guys are a great group of people!!
Thanks,
Rich
I've been wanting a CNC Router for a very long time. Only recently have I considered doing a build. In the past few weeks I have been spending a lot of time lurking around on the CNCZone DIY forum. A few days ago I was reading a comment from a veteran DIY'er who stated that his next build was going to be a MechMate. That was the first time I'd seen a reference to MechMate so naturally I came over here to check it out for myself. I'm quite impressed! I am still in the learning / planning stage but I've already downloaded the drawings and I have to say that of course Gerald has done an amazing job with the engineering side of things... He's also done an outstanding job maintaining the site and moderating the forum. I'm really looking forward to getting started and being an active member of the MechMate community!
I tend to do a lot of research so I probably won't start a build thread for awhile. I've been reading this forum non-stop but I still have a lot of reading to do. Just thought I'd start out by thanking everyone for their contributions. You guys are a great group of people!!
Thanks,
Rich