View Full Version : Profile cutting with cnc mill?
esadaddy
Tue 03 November 2009, 11:16
I was wondering have anyone discussed the possibilty of using a cnc milling machine to cut the profiles? I was wondering why I hadnt seen any post regarding using cnc mills to cut them. I am sure it will require a lot of additional holdown methods but I believe if the parts of similar thickness are nested correctly it should work. Correct?
Gerald D
Tue 03 November 2009, 12:17
Of course you can mill the parts, but that would be a lot more expensive than laser cutting........unless your milling is for free! :)
esadaddy
Tue 03 November 2009, 21:09
Yes, I will be milling them myself.
Gerald D
Tue 03 November 2009, 22:37
For milling, I would not nest them on sheets.
I would cut blanks and stack them up to mill 2 or 3 at a time where possible.
esadaddy
Wed 04 November 2009, 01:56
yes good idea. This will also maintain rigidity will cutting. I will just have to hand work the small corners with a set og good needle files.
IMMark
Mon 01 September 2014, 09:13
Don't forget that with the laser cut kits, the parts are bent as well.
Mark
wetong
Sat 27 September 2014, 19:23
:):):)
vBulletin® v3.8.3, Copyright ©2000-2024, Jelsoft Enterprises Ltd.