paul60
Thu 10 September 2009, 10:11
I am enclosing a photo of the power supply i will be using to power my PMDX-122 board.
what i am thinking is using the same power supply to power my Gecko cooling fans.
feeding the power to a connecting strip then supplying the PMDS and fans from there
is this a wise move? or should i have i have a independent supply to each.
I have also been checking other power supplies i have a home. What i have notice that the power supplies that have a resistor at the end, [as shown in the photo] if these outputs say 12volts then it reads 12v on my meter.
the others without the resistor can read anything from 14v to 16 volts.
thanks paul;
what i am thinking is using the same power supply to power my Gecko cooling fans.
feeding the power to a connecting strip then supplying the PMDS and fans from there
is this a wise move? or should i have i have a independent supply to each.
I have also been checking other power supplies i have a home. What i have notice that the power supplies that have a resistor at the end, [as shown in the photo] if these outputs say 12volts then it reads 12v on my meter.
the others without the resistor can read anything from 14v to 16 volts.
thanks paul;