Daniel T
Sat 22 August 2009, 16:03
Hi, I need to cut some stainless steel, it is really thin (0.5 mm) but im having trouble with the bits.
I have the manufacturers recomended bit but the problem is that the cutting length is about 11 meters so the bit gets really hot even with a mister at full power, and the bit only lasts 1 or maybe 2 of the 11 meter pieces and its getting really expensive...
any suggestions to how to fix this?
thank you very much
I have the manufacturers recomended bit but the problem is that the cutting length is about 11 meters so the bit gets really hot even with a mister at full power, and the bit only lasts 1 or maybe 2 of the 11 meter pieces and its getting really expensive...
any suggestions to how to fix this?
thank you very much