therion_339
Thu 18 June 2009, 15:45
Hey, im new here, my name is Luka, im an architecture student, living in Novi Sad, Serbia, i attended a "Computer electronics and programing" high school, but even though i ended up here i still try to keep this a active hoby...
Last summer i started building a CNC machine, pretty much from scrap i could find, bits and pieces of hardware, but after the finals this year i've decided to try and finish the job. I googled a bit, and found this awesome forum, didn't realize there were so many people interested in making this. Anyhow, im not at my workshop now, thats about 50km away, but i'll upload a few pics these days, just got the Z axis complete, its got a 30 000rpm Milling Head, for wood mainly. I whould very much appreciate some general advice, in terms of the general project, if there are some basic rulez about the work size, the machine components, where i could order a good electronic kit, etc.
Sry again about the lack of pic's and plans, will get to work on that asap.
Thanx in advance!
Last summer i started building a CNC machine, pretty much from scrap i could find, bits and pieces of hardware, but after the finals this year i've decided to try and finish the job. I googled a bit, and found this awesome forum, didn't realize there were so many people interested in making this. Anyhow, im not at my workshop now, thats about 50km away, but i'll upload a few pics these days, just got the Z axis complete, its got a 30 000rpm Milling Head, for wood mainly. I whould very much appreciate some general advice, in terms of the general project, if there are some basic rulez about the work size, the machine components, where i could order a good electronic kit, etc.
Sry again about the lack of pic's and plans, will get to work on that asap.
Thanx in advance!