javeria
Sat 13 June 2009, 11:12
folks - today while bowsing the local scrap yard - I noticed something -
it had a ball screw(THK) 25mm THK profiled linear slides - all mounted on a 35mm thk steel plat and a 25 mm thk plate mounted on the rails
It had a motion of 125mm overall - now folks I need you suggestion if i can aquire it and use it for the Z axis on teh mechmate - the asking price is approx USD 100.
if i get it then I will replace the bottom plate with an Alu plate - or probable junk all the steel and use sheet and alu to get it going on the mechmate
hope u folks can give some suggestions.
RGDS
Irfan
it had a ball screw(THK) 25mm THK profiled linear slides - all mounted on a 35mm thk steel plat and a 25 mm thk plate mounted on the rails
It had a motion of 125mm overall - now folks I need you suggestion if i can aquire it and use it for the Z axis on teh mechmate - the asking price is approx USD 100.
if i get it then I will replace the bottom plate with an Alu plate - or probable junk all the steel and use sheet and alu to get it going on the mechmate
hope u folks can give some suggestions.
RGDS
Irfan