Jayson
Sun 08 February 2009, 01:31
Got some 32mm mdf for the base and 16mm for the spoil board . Got the base screwed down and even managed to cut out a little project. I think the results are good and I am happy with the over all performance of the MM.
3628 3629
I believe that I may need to upgrade to belt reduction as I am not totally happy with the finish. Don't get me wrong, the results I am obtaining with direct drive are more than acceptable for a wood working machine, I would however like a slightly better finish
3630
These marks are fairly fine and could easily be removed with very little effort with some fine sandpaper and for a lot of projects these would not be of any great consequence.
The 3:1 belt drive might just be the solution. I will keep you all informed on how I get on.
Jayson.
3628 3629
I believe that I may need to upgrade to belt reduction as I am not totally happy with the finish. Don't get me wrong, the results I am obtaining with direct drive are more than acceptable for a wood working machine, I would however like a slightly better finish
3630
These marks are fairly fine and could easily be removed with very little effort with some fine sandpaper and for a lot of projects these would not be of any great consequence.
The 3:1 belt drive might just be the solution. I will keep you all informed on how I get on.
Jayson.