Kim Mortensen
Thu 08 February 2007, 16:26
http://cgi.ebay.com/4-AXIS-10-AMP-STEPPER-MOTOR-CNC-DRIVE-I-O_W0QQitemZ190080850 163QQihZ009QQcategoryZ71394QQrdZ1QQcmdZViewItem (http://cgi.ebay.com/4-AXIS-10-AMP-STEPPER-MOTOR-CNC-DRIVE-I-O_W0QQitemZ190080850163QQihZ009QQcategoryZ71394QQr dZ1QQcmdZViewItem)
I noticed it's only half or full steps it can use. But does anyone think it would be an acceptable drive board to use for the mechmate. It should have sufficiant power enough. But I'm concerned that the lack of microstepping will make the mechmate run a little rough.
I noticed it's only half or full steps it can use. But does anyone think it would be an acceptable drive board to use for the mechmate. It should have sufficiant power enough. But I'm concerned that the lack of microstepping will make the mechmate run a little rough.