PDA

View Full Version : Vectric Textures

Gerald_D
Sat 06 May 2006, 04:40
http://www.mechmate.com/Forum/messages/32/691.jpg
http://www.mechmate.com/Forum/messages/32/692.jpg
http://www.mechmate.com/Forum/messages/32/693.jpg

Pine and kiaat (http://iafrica.com/diy/carpentry/432328.htm) pieces about 8 to 10 inches square...
http://www.mechmate.com/Forum/messages/32/694.jpg
Gerald_D
Sat 06 May 2006, 04:43
http://www.mechmate.com/Forum/messages/32/696.jpg
http://www.mechmate.com/Forum/messages/32/697.jpg
http://www.mechmate.com/Forum/messages/32/698.jpg
http://www.mechmate.com/Forum/messages/32/699.jpg
Gerald_D
Sat 06 May 2006, 04:48
http://www.mechmate.com/Forum/messages/32/701.jpg

Then, a light touch of hand sanding.....
http://www.mechmate.com/Forum/messages/32/702.jpg

Then, brushed with shoe polish.....
http://www.mechmate.com/Forum/messages/32/703.jpg
http://www.mechmate.com/Forum/messages/32/704.jpg
Gerald_D
Sat 06 May 2006, 04:52
http://www.mechmate.com/Forum/messages/32/706.jpg
http://www.mechmate.com/Forum/messages/32/707.jpg
http://www.mechmate.com/Forum/messages/32/708.jpg
http://www.mechmate.com/Forum/messages/32/709.jpg
domino11
Mon 20 August 2007, 10:51
Gerald,
What size bit were you using for the texturing? I have also seen some pictures of a desk you did with the texturing as well. It looked impressive. Do panels with this texturing take a long time to cut?
Gerald D
Mon 20 August 2007, 12:14
Going from (bad) memory, the cutter is 38mm [1.5"] diam ball and it took about 30 to 40 mins to "texture" a 2.4mx1.2m [8'x4'] area?