rocky2889
Sat 28 March 2009, 20:00
I try to understand E-stop and limit switches. Yes, I finish wire a small machine and installed limit switches.
Every time the gantry trips the limit switch and it also trigger the E-stop LED on the Mach3, is this normal?
I will check into the wiring tomorrow but if trigger the E-stop that meant it cuts all power to the drives and how can you do auto home?
thanks
Every time the gantry trips the limit switch and it also trigger the E-stop LED on the Mach3, is this normal?
I will check into the wiring tomorrow but if trigger the E-stop that meant it cuts all power to the drives and how can you do auto home?
thanks