grandpi
Sun 17 February 2008, 13:18
Hello Gerald, Hello Guys,
Todays was the first steps (moves not cuts) of my mechmate !!.
Z moves ok, Y too. But on XX' the two motors went on opposite way !! so the mechmate went out of his rails !!. Wiring problems i suppose ?. I will have an answer from Laurent from Techlf during the week.
The interface of the new version of Isa4d (V2.1) is very cool.... Have a look.
Photos and videos during the weeks ...
Bye,
Pierre.
Todays was the first steps (moves not cuts) of my mechmate !!.
Z moves ok, Y too. But on XX' the two motors went on opposite way !! so the mechmate went out of his rails !!. Wiring problems i suppose ?. I will have an answer from Laurent from Techlf during the week.
The interface of the new version of Isa4d (V2.1) is very cool.... Have a look.
Photos and videos during the weeks ...
Bye,
Pierre.