View Full Version : Router / Spindle cable management
gmessler
Sun 19 October 2008, 18:39
For those of you with working Mechmates, how are you handling the wiring management of the z-slide? I think this would include cabling for the router/spindle power, ground wire, and in some cases the prox switch.:confused:
smreish
Sun 19 October 2008, 19:01
Greg,
I have a very stiff 3 core 12GA wiring for the router which I loop up and over the slide and zip tie to a nice hole I drilled in the slide plate. I will be adding cable chain to the slide in the very near future to make it all look sexy.
JR, I think has one of the cleanest arrangements I have seen so far.
Sean
vBulletin® v3.8.3, Copyright ©2000-2024, Jelsoft Enterprises Ltd.