PDA

View Full Version : servo selection


ashish_hal
Wed 24 September 2008, 05:48
Hi friends,
I got 2 servo motors of 4Nm torque of DELTA make and one YASHKAWA make.
both have 2500 ppr encoder installed. Can anyone tell me what is the maximum frequency that mach3 can handle for encoder input. Also is it better to use g100 instead of parellel port for the performance.


Thanks
Ashish

Gerald D
Wed 24 September 2008, 06:06
Sorry, you need to go to another forum.

ashish_hal
Wed 24 September 2008, 06:22
Hi friends,
I got 2 servo motors of 4Nm torque of DELTA make and one YASHKAWA make.
both have 2500 ppr encoder installed. Can anyone tell me what is the maximum frequency that mach3 can handle for encoder input. Also is it better to use g100 instead of parellel port for the performance.

And i hope this time its the right place.:confused:
Thanks
Ashish

Gerald D
Wed 24 September 2008, 07:13
Ashish, these forums will be much better for you:

http://www.machsupport.com/forum/index.php
http://groups.yahoo.com/group/mach1mach2cnc/
http://www.cnczone.com/forums/index.php
http://finance.groups.yahoo.com/group/geckodrive/messages